16AWG Asenware Fire Alarm Resistant Cable has been specially designed and thoroughly tested to retain its durability and reliability when fire strikes. A fire alarm system is reliant in no small part to the cabling that connects the devices and supplies power. Without reliable, robust cable the fire alarm system would be prone to costly faults and malfunctions. It is therefore essential that you only use the best cable, fitted by qualified electricians, in your fire alarm system. 16AWG Asenware Fire Alarm Resistant Cable Specifications:- Type : Insulated Conductor Type: Solid Application: Heating Conductor Material: Copper Sheath Material: PVC Diameter: 1.5mm

The standalone smoke detector is designed to protect you and your family from the dangers of smoke and fire, the Ei 100BQWX continuously monitors for the signs of smoke and fire even if in the event of power loss in your home. It has an easily visible test button and the alarm will warn you when the battery needs replacing by giving an intermittent “beep” sound. Easy to install and comes complete with battery and fixing kit. The Standalone smoke detector Ei 100BNX is tested, accredited, and Kitemarked by BSI to EN 14604; 2005 and has a 5-year Guarantee. Sufficient smoke must enter your standalone smoke detector before it will respond. Your Smoke detector needs to be within 10 paces (23 feet)of the fire to respond quickly. It also needs to be in a position where its alarm can be heard throughout your home, so it can wake you and your family in time for you all to escape. A single Smoke Alarm will give some protection if it is properly installed, but most homes will require two or more to ensure that a reliable early warning is given. For maximum protection, you should put individual Smoke Alarms in all the rooms where the fire is most likely to break out. Your first Smoke Alarm should be located between the sleeping area and the most likely sources of fire (living room or kitchen for example). But it should not be more than 10 paces (seven meters) from the door to any room where a fire might start and block your escape from the house.

Asenware Manual Call Point is designed to be used with an intelligent two-wire control system. If it is pressed after a fire is manually confirmed, an alarm signal may be sent to a fire alarm control system which will, after receiving the alarm signal, display the equipment status of the manual fire call points. When the manual fire call points are operating normally, the red indicator will blink; when there is a fire alarm, it will remain lit. 1 Semi-flush or surface mounting 2 Compatible with the latest EN standards 3 Lever reusable (non-glass break) 4 LED indicator

Fire Blanket big size 1.8m by 1.8m is made of fiberglass material to shield you from serious burns. It can be used to smother down fires or used to wrap around a person whose clothes have caught fire. Placed in or around areas where a fire is likely to start, most likely around kitchen areas, gas stations, warehouses, and so on. The fire blanket is discarded after use. Fire blankets are designed for quick release and deployment and ideally, should be sited in view for emergency access, close to the area of fire risk. In the home where wall hanging may be obtrusive, the blanket can be hung on the inside of a kitchen cupboard door close to the cooking area. Once deployed over the fire, leave for several minutes until all signs of fire have disappeared. Normally fire blankets are not reusable if the outer sleeve is damaged by the fire allowing the ingress of oxygen.